11-03-2009, 10:53 AM
|
Administrator
|
|
Join Date: Oct 2009
Posts: 5,409
|
|
Inspection with Task List and/or Material Specification
Inspection with Task List and/or Material Specification
If you want to inspect with a task list, material specification, by batch or according to configuration, you must make entries in the inspection type fields and for the indicators as follows:
Indicators/Fields to be Set
- Insp. with task list
- Insp. with mat. spec.
- Insp. by configuratn
- Insp. by batch
- Q-score procedure
- Allowed s**** share
Optional Indicators/Fields
The following indicators are optional, depending on which inspection type you select and how you want to record the inspection results.
- Automatic assignment
- Insp. by charac.
If you want to inspect with a task list, without recording results by characteristic, you must not set the Insp. by charac. indicator. In this case, you can make shop papers available to the inspector in the form of an inspection instruction, containing a list of inspection characteristics.
- 100% inspection
- Dyn. mod. rule
- Skips allowed
When an inspection lot is created, you can enter the planned start date of the inspection. The system then calculates the planned end date of the inspection (or vice versa).
Indicators/Fields Not to be Set
See also:
Inspection Without a Task List or Material Specification
Last edited by seema; 11-03-2009 at 10:53 AM.
|